LAVAZZA LB 2500 PLUS Guide D'utilisation page 30

Masquer les pouces Voir aussi pour LB 2500 PLUS:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
E N
This value can be measured with the special colour
changing strips available on the market.
A value in a range between 5 and 50 French de-
grees can be input with buttons 4 and 5.
This value is set by default to 20 French degrees. If
a water softener filter is used, set a water hardness
value based on the hardness abatement capability
of the filter.
DELTA TEMP
By confirming "Delta Temp" with "Enter", it is pos-
sible to change the working temperature of the
boiler so as to slightly increase or reduce the tem-
perature of the dispensed product. The value can
be increased or reduced by a range of ±4 °C using
buttons 4 and 5.
CHANGE PASSWORD
By confirming the "Change Password" item with
"Enter" the display will show:
PASSWORD
At this point you can input your desired password
which must be composed of 6 characters.
You can then confirm the password using the "En-
ter" button. Press the "Esc" button one or more
times to go back to previous menu levels or to exit
the menu.
ENERGY SAVING
The machine is programmed to be able to go into
energy saving mode after a certain time of inactiv-
ity. The preset value is 2 hours.
In Energy Saving mode the display on the machine
shows:
ENERGY SAVING
To bring the machine back to ready mode it is suf-
ficient to press any selection button. By confirm-
ing the "Energy Saving" item with "Enter" you can
choose between the following two options by
pressing the 4 and 5 buttons:
Energy saving deactivated
Energy saving activated
You can choose to activate or deactivate Energy
Saving using the "Enter" button.
Press the "Esc" button one or more times to go back
28
SETTINGS MENU
to previous menu levels or to exit the menu.
START PUMPS
By confirming the "Start pumps" item with "Enter"
you can choose between the following two options
by pressing the 4 and 5 buttons:
Start pumps activated
Start pumps deactivated
You can choose to activate or deactivate the func-
tion using the "Enter" button.
Press the "Esc" button one or more times to go back
to previous menu levels or to exit the menu.
The start pumps function can be executed, in ma-
chine ready mode, by pressing buttons 3 and 6 at
the same time for at least 3 seconds.
Before activating the start pumps function
a cup or glass must first be positioned under
the nozzle, on the cup-support rack.
During start pumps the display will show the fol-
lowing message:
According to the result of the process and at the
end of it, the display will show the following mes-
sage.
When the machine is started for the first time or af-
ter a prolonged period of not being used, it may be
necessary to refill the water system. The function, if
activated beforehand from the menu, is executed
automatically by the machine by pressing buttons
3 and 6 at the same time for at least 3 seconds.
CARD CHECK
This function allows the operator to check a chip
card, independently of its use. By confirming the
"Check card" item with "Enter" the display will show
the following message.
START
PUMPS IN PROGRESS
START PUMPS
POSITIVE/NEGATIVE
INSERT CARD

Publicité

Table des Matières
loading

Table des Matières