Before Starting The Equipment - EINHELL BG-PM 51 SD Mode D'emploi D'origine

Anleitung_BG_PM_51_SD_SPK7__ 10.09.12 13:30 Seite 25

6. Before starting the equipment

6.1 Assembling the components
Some parts of the mower come disassembled. For
quick and easy assembly, read and follow the
instructions below.
Important. You will need the following additional
tools (not supplied) for assembly, and also for
maintenance work:
A flat oil drip tray (for changing the oil)
n
A 1 liter measuring jug (oil/petrol resistant)
n
A petrol can
n
A funnel (suitable for the tank's petrol filler neck)
n
Household wipes (to wipe up oil/petrol residue;
n
dispose of these at a filling station)
A petrol suction pump (plastic, available from DIY
n
stores)
An oil can with hand pump (available from DIY
n
stores)
Engine oil
n
Assembly
1. Fasten the push handle (Fig. 3a / Item 3) with one
screw (Fig. 3a / Item 10) and one nut (Fig. 3a /
Item 9) each on either side, making sure that the
cable pulls to be installed later on are not in the
way.
2. Unfold the push bar and fix it into place by
tightening the star screws as shown in Figure 3b.
3. Insert the grip of the starter cord (Fig. 3c/Item 7)
into the hook provided for that purpose as shown
in Figure 3c.
4. Fasten the cords to the push bar with the supplied
cable clips (Fig. 3d/Item 8).
5. To assemble the side discharge adapters, first
move them in position (Fig. 4a) and then tighten
the preassembled as shown in Fig. 4b. For
disassembly, please proceed in reverse order.
6.2 Setting the cutting height
Important. Adjust the cutting height only when
the engine is switched off and the plug boot has
been pulled.
Before you begin to mow, check to ensure that
n
the blade is not blunt and that none of the
fasteners are damaged. To prevent any
imbalance, replace blunt and/or damaged blades
as a set only (if applicable). To carry out this
check, first switch off the engine and pull the
spark plug boot.
NB: For easier replacement of the wheels opposite
the side discharge adapter please remove the wheels
as specified under 6.1.5.
The cutting height is not adjusted at a single
n
central point – instead, each of the 4 wheels
have to be adjusted separately. Three different
cutting heights are available. (As-delivered state:
Medium cutting height)
Caution: All 4 wheels have to be set to the same
cutting height.
1. Open the wheel bolt (Fig. 7a).
Important: There is a metal washer between the
wheel and the mower housing. Make sure that
you fit this washer back in place between the
wheel and the housing during reassembly.
We recommend that you first change both
wheels on one side followed by both wheels on
the other side.
2. Remove the wheel and screw it back on tightly in
the desired position (Fig. 7b).
Position 1: Low cutting height
Position 2: Medium cutting height
(As-delivered state (sufficient for normal use)).
Position 3: High cutting height
GB
25