Makita 2705 Manuel D'instruction page 6

Switch action
ON
► 1. Switch
CAUTION:
• Before plugging in the tool, always be sure that
the tool is switched off.
To start the tool, raise the switch lever. To stop it, lower
the switch lever.
The hinged switch lever plate can be locked by passing
padlock through the hasp on the left hand side.
► 1. Padlock
Sub table (R)
1
► 1. Lever
OFF
1
1
► 1. Sub table (R)
This tool is provided with the sub table (R) on the right
side of the main table. To use the sub table (R), raise
both levers on the front right side, pull out the table (R)
fully and then lower the levers to secure it.
When using the sub table (R ), locate the scale plate
on the sub table after loosening the screw on it with
a screwdriver so that it becomes successive with the
scale plate on the main table.
1
► 1. Scale plate 2. Screw
Sub table (back) and sub table (L)
(BOTH optional accessories)
1
► 1. Sub table (back) 2. Screw
To use the sub table (back), loosen the screws on the
left and right hand sides under the table and pull it out
backwards to the desired length. At the desired length,
tighten the screw securely.
6 ENGLISH
1
2
2