Publicité
Les langues disponibles
Les langues disponibles
2.
For ease of guard assembly installation adjust
the table saw for maximum depth of cut. With the
locking lever released as shown in Figure 1, posi-
tion the locking lever pin center groove into the
notch provided on the riving knife/spreader unit as
shown in figure 2.
Fig.2
► 1. The notch provided on the Riving Knife/Spreader
for the locking lever pin center groove 2. Locking
lever pin sleeves 3. Locking lever pin center groove
3.
Once the locking lever pin is placed into the riving
knife/spreader notch it is to be locked into position
by pushing the tab of the pin's locking lever into
the locked position as shown in Figure 3. Once the
pin's locking lever is in the locked position check
to ensure that the guard assembly is properly
attached to the riving knife/spreader assembly by
pulling up on the guard assembly and making sure
it does not move its position.
WARNING:
•
Always ensure proper attachment of the
guard assembly to the Riving Knife/Spreader
before turning the saw on. Improper attach-
ment of the guard assembly could result in the
saw blade making contact with the guard, caus-
ing serious injury.
Fig.3
► 1. Locking Lever in the locked position 2. Locking
Lever tab
To remove the blade guard for non through cutting
operations reverse the above steps 1 - 3.
2
3
1
Installation of Side Guards to Blade
Guard Assembly
WARNING:
•
The guard assembly and side guards should
only be used with the riving knife/spreader in
the spreader position to prevent guard inter-
ference with the work pieces. The use of the
guard assembly with the riving knife/spreader in
the riving knife position may cause interference
with the work piece resulting in a kickback situa-
tion and possible serious personal injury.
1.
Release the locking lever pin of the side guard by
lifting the locking lever tab as shown in figure 1.
1
3
► 1. Side Guard Locking Lever in the released posi-
tion 2. Side Guard Locking Lever Tab 3. Side Guard
Locking Lever Pin
2.
With the locking lever pin released position the pin
into the notch provided on the blade guard assem-
bly as shown in figure 2.
Fig.2
2
► 1. The Notch provided in the Blade Guard Assembly
2. Place locking lever pin into the blade guard
assembly
10 ENGLISH
1
2
Fig.1
2
1
Publicité
