Publicité
Les langues disponibles
Les langues disponibles
Storage of Blade Guards and
Accessories
► 1. Miter gauge
► 1. Rip fence 2. Push stick
1
► 1. Table saw blade guard assembly and side guard
storage
The miter gauge, blade and wrenches can be stored
on the left side of the base and the rip fence can be
stored at the right side of the base. The Blade Guard
Assembly and Side Guards can be stored inde-
pendently in the pocket provided on the right side of the
table base.
1
1
2
Installing and adjusting rip fence
WARNING:
•
Always be sure the tool is switched off and
unplugged before attempting to perform the
installation and adjustment of the rip fence.
► 1. Guide rail 2. Knob 3. Hook
1) Fit the hook on the tip of the rip fence into the far
guide rail on the table or sub table (R) and install and
push the rip fence forward so that the fence holder
engages with the nearmost guide rail.
To slide the rip fence on the guide rail sideways, pivot
the knob on the fence holder to the half way of its travel.
To secure the rip fence, pivot fully the knob on the fence
holder.
2) To slide the rip fence on the guide rail sideways,
return the knob on the fence holder fully without pulling
the lever on the knob.
3) To remove it, pull the lever on the knob and pivot the
knob fully forward while pulling the lever.
To check to be sure that the rip fence is parallel with the
blade, secure the rip fence 2 - 3 mm (5/64" - 1/8" ) from
the blade. Raise the blade up to maximum elevation.
Mark one of the blade teeth with a crayon. Measure
the distance (A) and (B) between the rip fence and
blade. Take both measurements using the tooth marked
with the crayon. These two measurements should be
identical. If the rip fence is not parallel with the blade,
proceed as follows:
A
► 1. Scale
12 ENGLISH
1
2
3
B
1
Publicité
