Publicité
Les langues disponibles
Les langues disponibles
WARNING:
•
Do not use dado headsets wider than 21mm
(13/16") or dados greater than 6" in outmost
diameter.
•
After dadoing, ALWAYS properly adjust the riv-
ing knife/spreader and replace the blade guard
assembly and side guards for through cuts.
•
NEVER attempt bevel cuts when dadoing.
•
NEVER dado if there is vibration (flutter) or a
strange noise.
•
Feed work slowly, especially when cutting
deep or wide grooves or dados. If a deep cut
is needed, make several passes through the
workpiece rather than one deep, wide cut. Fast
or abrupt feeds can be dangerous.
•
Use a push stick. When the dado head is hid-
den from view while cutting, your hands should
never be on top of the stock.
•
A very dangerous throwback can result if the
wood becomes stuck and you try to remove it by
pulling toward you. Always stop the tool and wait
for dado head to come to a complete stop. Then
simply withdraw the wood.
•
Use extra caution when the guard assembly is
removed for any non-through sawing operation
such as dadoing, rabbeting or re-sawing. Adjust
the riving knife/spreader and replace the guard
assembly and side guards.
How to perform rabbeting
1
► 1. Rabbet 2. Second cut 3. First cut
1.
Remove blade guard assembly and properly adjust
the riving knife/spreader to the riving knife poisiton.
2.
Attach auxiliary fence to rip fence for cuts that run
the length of the stock. Facing should be as high
as the workpiece is wide. Adjust fence and blade
to desired dimensions.
3.
First cut: Hold board flat on table as in ordinary
ripping.
4.
Second cut: Set workpiece on its edge. (Use
featherboards, push stick, push block and so on,
using precautions, safety rules and guidelines for
ripping or related work.)
5.
For end-type rabbeting, if the workpiece is less
than 10-1/2" wide, rest the wood flat on the table
against the miter gauge (with wood facing). The
rip fence should not be used.
6.
When moving from a rabbet cut operation to
a through cut operation adjust the riving knife/
spreader to the spreader position and install the
guard assembly and side guards.
Table stand set (accessory)
Refer to the instruction manual for table saw stand
that is provided with the table saw stand as an optional
accessory.
•
Steel & Carbide-tipped saw blades
Table/Miter saw
blades
Combination
Fine cross cuts
•
Sub table ( L)
•
Sub table ( back)
•
Rip fence
•
Miter gauge
•
Offset wrench 13-22
•
Wrench 19
•
Hex wrench 5
•
Auxiliary plate
•
Stand set
•
Sliding guide
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
MAKITA LIMITED WARRANTY
2
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this product.
If annexed warranty sheet is not available, refer to the
warranty details set forth at below website for your
respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com
3
19 ENGLISH
For general purpose cuts for table and miter saws.
General purpose blade for fast and smooth rip,
crosscuts and miters.
For sand-free cuts cleanly against the grain.
Publicité
