Before Use; Removing/Charging/Inserting The Battery Pack; Checking The Battery Charge Level; Fitting The Attachments - Parkside PAAP 12 A1 Traduction Des Instructions D'origine

Before use

Removing/charging/inserting the
battery pack
NOTE
► The battery is supplied partially charged.
Before first use, charge the battery in the
charger for at least 1 hour. This guarantees
full battery performance. You can charge the
lithium-ion battery at any time without
shortening its service life. Interrupting the
charging process does not damage the
battery.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between
0°C and 50°C.
CAUTION!
► Always unplug the appliance before you
remove the battery pack
it to the charger.
♦ To remove the battery pack
release button and pull the battery pack
out of the appliance.
♦ Insert the battery pack
charger .
♦ Insert the power plug into the socket. The
charge control LED
♦ The green charge control LED
charging is complete and the battery pack
is ready for use.
♦ Unplug the high-speed charger from the wall
socket.
♦ Push the battery pack
PAAP 12 A1
from or connect
, press the
into the high-speed
lights up red.
indicates that
into the appliance.

Checking the battery charge level

When the appliance is switched on, the remaining
charge is shown on the battery LED
RED/ORANGE/GREEN = maximum charge
RED / ORANGE = medium charge
RED = low charge – charge the battery
Assembly/disassembly of the
polishing disc
♦ Press the spindle lock
♦ Screw the polishing disc
screw thread .
♦ Proceed in the reverse order to remove the
polishing disc .

Fitting the attachments

ATTENTION!
► Be sure to remove the battery pack before
fitting or removing the attachments
, .
♦ The polishing disc
, , , are fitted with corresponding
Velcro fasteners.
♦ To change them, lift the side of the attachment
, , , and pull it off the polishing
disc .
♦ First choose a sandpaper
press it onto the polishing disc
it is properly centred.
♦ Now select the polishing hood
pre-polishing and push it onto the polishing
disc . Make sure it is properly centred.
♦ Now select the polishing hood
final polishing and press it onto the polishing
disc . Make sure it is properly centred.
♦ For the final finish, select the fake fur attachment
and press it onto the polishing disc
Make sure it is properly centred.

Fitting the additional handle

♦ The additional handle
the left or right side of the appliance head,
depending on the mode of operation.
as follows:
and hold it down.
clockwise onto the
, ,
and supplied attachments
for sanding and
. Make sure
(orange) for
(black) for
.
can be screwed onto
GB │ IE │
25 ■