cecotec CONGA 3590 Manuel D'instructions page 34

ENGLISH
Clean the main brush with the provided tools and use water and soap if necessary.
Place the main brush in its position and fasten the cover's clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 17.
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
Silicone brush
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before assembling it back in order
to ensure efficient operation.
Cepillo Jalisco (brush)
To clean the Jalisco brush, follow the previous section's steps to take it out and clean it with
water.
Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank
Open the robot's cover and take out the dust tank.
Open the dust tank, take the high-efficiency filter out and empty the dust.
Use a cleaning brush to clean the tank's inner part and reinstall the high-efficiency filter.
Introduce the dust tank back into the robot and close the top cover.
Fig. 18.
High-efficiency filter
Fig. 19.
Remove the high-efficiency filter and shake it to remove all the dust.
Recommendations:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage.
Wash the filter with lukewarm water, do not use detergents.
Side brush
Fig. 20.
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
33