cecotec CONGA 3590 Manuel D'instructions page 32

ENGLISH
Thanks to its Total Surface 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it will
resume the cleaning process from the same point, offering a high-efficiency cleaning. During
cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning route (this
stop will vary depending on the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas, therefore it might
leave the room where it is cleaning to finish off the delimited area. Do not worry, the robot will
clean all the accessible surface.
Edge mode
Fig. 15.
Press the Edge mode button on the App for the robot to start cleaning along the edges. It will
automatically start cleaning along all the surface's perimeters and then will return to the
charging base direct and automatically. If the robot has not started cleaning from the charging
base, it will return to the starting point.
Note: Press the power levels button to switch between the 3 modes: Turbo/Normal/Eco.
Back home mode
Fig. 16.
Press the back home button on the App in order to send it to the charging base. This function
can be activated during any other cleaning cycle and the robot will automatically return to the
charging base and stop the cleaning process. The robot will take the shortest route back to the
charging base thanks to its map memorizing and the smart back home function.
When a cleaning cycle has been completed or the robot's battery is low, thanks to its Total
Surface 2.0 technology, the robot will also return to the charging base to avoid running out of
battery. Once the robot has recharged, it will resume cleaning from the point it has stopped.
Note:
Remove the Wet & dry tank from the robot before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the robot can get to the
charging base without problems.
Spiral mode
The robot is placed on a specific point, it starts cleaning in an outward spiral motion, and then
returns to the starting point in an inward spiral motion again. If the robot bumps into an object,
it will finish the cleaning cycle moving in the opposite direction in a spiral motion.
Manual mode
The robot can be manually controlled with the direction arrows on the display.
The robot will move in the selected direction as the arrow is being pressed.
31