IKA A10 basic Mode D'emploi page 20

Disconnect the mains plug prior to
tools!
Hold the grinding tool securely in place with the bracket.
with socket wrench SW 8 as indicated in following Fig. 7.
Fig. 7
moved from the chamber.
Fig. 8
Note: When removing the A10.2 Star-shaped beater, use
the hooks on the bracket to hold the cutter. Then, the cut-
ter can be taken out of the chamber (see
SW 8
bracket
-
observe the safety instructions.
Hex. nut
After set the new or another grinding tool in place, tight-
Grinding tool
use the tools as shown in Fig. 7.
mill must first be allowed to cool off.
Before assembling a new or another pulverization tool,
make certain that all parts are clean.
The edges of the blade are
DANGER
Note that when changing the tool
DANGER
directly after a grinding procedure,
the pulverization tools are hot. The
).
Fig. 9
hook
Fig. 10
A17
hook
20