Commissioning; Timer Function; Interval Function - IKA A10 basic Mode D'emploi

Pay attention to the ambient conditions listed in the
"Technical data".
Check whether the voltage specified on the type plate
matches the mains voltage available.
The power socket used must be
earthed (protective earth).
If these conditions are met, the device is ready to operate
after plugging in the mains plug.
If these procedures are not followed, safe operation cannot
be guaranteed and/or the equipment may be damaged.
Attach the grinding chamber cap
WARNING
by twisting it clockwise after filling
grinding material. The cap is correctly
attached only after two "click"!
In stop status, press the Timer "-" button (F) and "+" but-
ton (G) to adjust the timer value. Adjusting magnitude of
the timer is 1 second.
Keep pressing the Timer "-" button (F) or "+" button (G),
value is 5 minutes (5:00).
When the timer is activated, the value on the display will
countdown.
When the timer is deactivated, the instrument will auto-
matically count from 0 second (0:00) to 5 minutes (5:00)
and then the unit will stop running.
In stop status, press the button "Int" key (D), the interval
function will be activated. The "Int" LED (E) lights up.
If timer function is activated, when the interval function
is activated, the instrument run 15 seconds and stop 1
second repeatedly until the setting time run out.

Commissioning

click
click
proper engage
position
Fig. 6

Timer function

Interval function

When the mains plug is plugged in, all of the LEDs light up
briefly during the self check.
Then, the software version is displayed.
After the software version, the right bottom LED lights up
to indicate the power is connected.
Press ON/OFF switch (A), the display will show the "Timer"
and "Int" setting.
Press the Start/Stop key (B), the instrument will start to run
If the grinding chamber cap is not attached properly, the
LED display three dashes (– – –) and grinding can not start.
Then, please check if the chamber cap is twisted to the stop
position after two "click".
If three dashes (– – –) don't disappear after the cap is cor-
rectly attached, please send the instrument for repair.
Note: When the interval function is activated by pressing
"Int" button (D), the "Int" LED (E) lights up.
After the instrument runs 5 minutes,
WARNING
it should stop 10 minutes for cool-
ing the motor. Then the user could
start the instrument again by pressing Start/Stop button
(B) again as request.
If timer function is deactivated, when the interval function
is activated, the instrument run 15 seconds and stop 1
second repeatedly until 5 minutes (5:00) elapse.
19