DeWalt DW935K2 Mode D'emploi page 24

Checking and changing the saw blade
• Only saw blades conforming to the specifications
contained in these operating instructions may
be used.
• Saw blades made of high alloy, high speed steel
(HSS steel) should not be used.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent
saw blades should be discarded and replaced
at once.
• Ensure that the saw blade is securely fixed and
rotates in the correct direction.
Special applications
• When cutting narrow workpieces
(width less than 80 mm) longitudinally,
use a rip fence guide along the longitudinal edge.
• When sawing with the workpiece clamped tight,
devices should be used to prevent the workpiece
kicking back.
• When sawing circular sections of wood use
a device to hold the workpiece steady on both
sides of the saw blade to prevent slipping.
• Ensure that pieces of wood sawn off the
workpiece cannot be caught up by the teeth of
the saw blade and thrown in the air.
Guard against kickback
• Kickback occurs when the saw begins to stall
rapidly and is driven back towards the operator.
Release the switch immediately if the blade sticks
or the saw stalls.
• Keep the saw blades sharp.
• Supports large panels near the cutting area.
• Use a fence or straight edge guide when ripping;
do not force the tool.
• Do not remove the saw from the work during
a cut while the saw blade is rotating.
Package contents
The package contains:
1 Cordless Trim Saw
1 Saw blade
1 Allen key
1 Parallel fence (DW936K2)
2 Battery Packs
1 Battery Charger
1 Kitbox
19
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your D WALT Cordless Trim Saw has been
E
designed for professional sawing applications.
1 ON/OFF-switch
2 Lock-off button
3 Front handle
4 Blade lock button
5 Dust spout
6 Bevel adjustment knob
7 Kerf indicator
8 Riving knife
9 Blade clamping screw
10 Lower guard
11 Lower guard retracting lever
12 Shoe
13 Depth adjustment knob
14 Parallel fence (DW936K2)
15 Battery pack
Charger
Your D WALT 1 hour charger accepts D
E
battery packs ranging from 7.2 to 14.4 V
(DW935K2) or 7.2 to 18 V (DW936K2)
15 Battery pack
16 Release buttons
17 Charger
18 Charging indicator (red)
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
power corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double
E
insulated in accordance with EN 50144.
E N G L I S H
WALT
E
en - 4