DeWalt DW935K2 Mode D'emploi page 23

E N G L I S H
16 Remove the battery pack
Remove the battery pack when not in use,
before servicing and when changing accessories.
17 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety instructions for battery packs
Fire hazard! Avoid metal short circuiting
the contacts of a detached battery pack
(e.g. keys carried in the same pocket as
a battery pack).
• The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin
contact, flush immediately with water.
Neutralize with a mild acid such as lemon juice or
vinegar. In case of eye contact, rinse abundantly
with clean water for at least 10 minutes.
Consult a physician.
• Never attempt to open a battery pack for any
reason.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
100%
Battery charging
100%
Battery charged
Battery defective
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
en - 3
Use only with D
others may burst, causing personal injury
and damage
Do not expose to water
Have defective cords replaced
immediately
+40 ˚c
+4 ˚c
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
Additional safety rules for circular saws
When sawing
• Remove all nails and metal objects from the
workpiece before starting work.
• Do not attempt to saw extremely small
workpieces.
• After switching OFF, never attempt to stop the
saw blade by pressing against the side of the
blade.
• Never put the saw down on a table or work
bench unless switched OFF.
Operational protection devices
• The circular saw must only be used for cutting
wood or plastic.
• Ensure that all devices screening the saw blade
are in perfect working order.
• Never jam the saw blade guards.
• Free a jammed saw blade guard immediately and
do not use the saw if the guard is jammed.
• Do not remove the riving knife.
• The riving knife should be correctly set;
the distance between the toothed rim and the
riving knife should be max. 5 mm and the height
difference between the riving knife and the
toothed rim should be max. 5 mm (fig. E).
WALT battery packs,
E
18