Mennekes AMTRON Wallbox Guide D'installation page 10

3 Installation
Wechsel ein-auf zweispaltig
Fig. 2: Mounting of stainless steel column
Wechsel ein-auf zweispaltig
For mounting, MENNEKES recommends threaded bolts
and nuts both made of stainless steel with a strength
class of at least 8.8. Use only threaded bolts and nuts
made of stainless steel to prevent corrosion.
A separate supply line should be provided for each
AMTRON® charging station.
A
Create bedplate using six threaded bolts M10
accordance with the measurements shown on Page
"Information on the prefabricated bedplate" on page 5.
Cable length from top edge of bedplate approx. 2.5 m!
Alternatively, a prefabricated bedplate can be purchased
directly. Please refer to Page
<dg_ref_source_iline>Bestellinfos
Fundament</dg_ref_source_inline>.
Wechsel ein-auf zweispaltig
2
B
Remove bolts
insert for this purpose. Slide cover
C
Set the stainless steel column on the bedplate. Feed
connection cable
out of the uppermost cable outlet of the stainless steel
column.
D
Bolt stainless steel column down using six VA nuts M10
1
in
and tighten using a torque wrench (tightening torque
depends on selected threaded bolt size).
If necessary, integrate the stainless steel column into the
equipotential bonding / earthing system. A connection
point is provided on the stainless steel column's base
plate for this purpose.
"Information on the prefabricated bedplate" on page 5
2
on the base plate; use the supplied bit
3
upwards.
4
into the stainless steel column and