Denon DN-C630 Mode D'emploi page 22

14) "FadeIn OFF (***s)"
FadeIn OFF (***s)
15) "Normal (+/–***%) Speed"
* Normal Speed
(+/–***%) Speed
16) "Delay OFF (***ms)"
Delay OFF (***ms)
17) "PlayLock ON (OFF)"
PlayLock ON
* PlayLock OFF
18) "FR Disp ON (OFF)"
* FR Disp ON
FR Disp OFF
19) "CD-R NO TOC ON (OFF)"
* Normal Disc
No TOC Disc
NOTE:
For CDR discs without TOCs, there are no pits (signals) at the disc's lead in and lead out sections, so errors may occur, particularly
when searching for tracks. If an error should occur, open the disc holder, then close it and perform the operation again.
20) "Remote EMA (INH)"
* Remote ENA
Remote INH
21) "St. Tally ON (OFF)"
* St. Tally ON
St. Tally OFF
22) "(******) Tally"
* INDEX 2 Tally
INDEX 3 Tally
23) "Fader Pause (Play)"
* Fader Pause
Fader Play
24) "Stereo (Mono)"
* Stereo
Mono
25) "Preset Clr ? (Ini. Preset)"
Preset Clr ?
* Ini. Preset
26) "Ver. xxxx"
: Set the fade in time. (*OFF/10 m/50 m/0.1/0.5/1/2)
: Play at normal speed.
: Play at variable speed. ±(0.2/0.4/0.6/0.8/1.0/1.2/1.4/1.6/1.8/2.0/2.2/2.4/2.6/2.8/3.0)
: Set the time for delayed start after the play start operation. (*OFF/100 m/200 m/300 m)
: Inhibit all operations other than the PLAY/PAUSE, TIME and PLAY MODE buttons during playback.
: Enable all functions during playback.
: Display the frames on the time display during playback.
: Do not display the frames on the time display during playback.
(The frames are displayed in the manual search, standby, pause and end monitor modes.)
: Play normal CD and CDR discs containing TOCs.
: Play CDR discs not containing TOCs.
: Enable input of control signals to the parallel remote connector.
: Inhibit input of control signals to the parallel remote connector.
: Output standby tally from parallel remote connector.
: Do not output standby tally from parallel remote connector.
: Output index 2 tally signal to remote pin (17).
: Output index 3 tally signal to remote pin (17).
: Start playback when remote fader pins (9-10) are short-circuited and pause when pins are open.
: Start playback when remote fader pins (9-10) are short-circuited and continue playback when pins are
open.
: Output L and R stereo signals from the output connector.
: Output mixed L and R signals from the output connector.
: Clear the presettings (set to the initial factory values).
: Do not clear the presettings.
: Display the microprocessor version. ("xxxx" is a number.)
ENGLISH
23