VONROC DS502AC Traduction De La Notice Originale page 7

• Make sure that the workpiece is properly sup-
ported or fixed.
• Only use sanding paper that is suitable for use
with the machine.
• Only use sanding paper with the correct
dimensions. Make sure that the sanding paper
is properly mounted.
• Inspect the sanding paper before each use.
Do not use sanding paper that is worn because
of prolonged use.
• Never put the machine down on a table or a
workbench before it has been switched off.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a mini-
mum thickness of 1.5 mm
sion cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
The machine is designed for sanding walls and
ceilings, for sanding smoothed drywalls, for remo-
ving paint, wallpaper and adhesive remnants. It is
not permitted to use cutting-off wheels, roughing
wheels, fan-like grinding wheels or wire brushes. The
machine is not suitable for processing objects con-
taining asbestos. Improper use may damage the tool.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Frequency
Power input
No-load speed
Disc diameter
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration
WWW.VONROC.COM
. If you use an exten-
2
DS502AC
220-240V ~
50/60 Hz
1050W
600-2600/min
Ø 215 mm
5.04 kg
93+3 dB(A)
104+3 dB(A)
4.16+1.5 m/s
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
Fig. A
1. On/off switch
2. Speed adjustment wheel
3. Hinge
4. Upper handle
5. Middle handle
6. Lower handle
7. Dust hose connector
8. Dust hose
9. Dust bag
10. Clip
11. Strap
12. Sanding pad cover
13. Hinge lock
14. Telescopic extension
15. Telescopic extension connector
16. Sanding pad
17. Sanding paper
18. Hex key holder
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
EN
7