Klein Tools VDV Scout Pro Mode D'emploi page 2

ENGLISH
The Klein Tools VDV Scout™ Pro is a portable voice-data-video cable tester. It tests and troubleshoots RJ11, RJ12, RJ45, and
F-connector terminated cables and provides built-in tone generation for cable tracing.
features with length measurement.
Sections and lines marked [LT] and in RED are relevant only to VDV501-068 VDV Scout™ Pro LT.
• Dimensions: 6.4" x 2.8" x 1.4" (16.3 x 7.1 x 3.6 cm)
• Weight: 9.0 oz. (256 grams) with battery and remote
• Operating Temperature: 0°C / 32°F to 50°C / 122°F
• Storage Temperature: -20°C / -4°F to 60°C / 140°F
• Humidity: 10% to 90%, non-condensing
• Maximum Voltage between any two connector pins
without damage:
• RJ Jack: 66V DC or 55V AC
• F-Connector: 66V DC or 55V AC
• Battery Life: 9V alkaline battery typical
• Standby: 4 years
• Active: 425 hours
• Cable Types: Shielded or Unshielded; Cat-7, Cat-7a,
Cat-6a, Cat6, Cat-5e, Cat-5, Cat-4, Cat-3, Coax
To ensure safe operation and service of the tester, follow these instructions. Failure to observe these warnings can result in severe
injury or death.
• The VDV Scout™ Pro is designed for use on unenergized cabling systems. Connecting the VDV Scout™ Pro to live AC power
may damage it and pose a safety hazard for the user.
• Poorly terminated RJ plugs have the potential to damage the jacks on the VDV Scout™ Pro. Visually inspect an RJ plug before
inserting it into the tester. The contacts should always be recessed into the plastic housing of the plug. Plugging 6-position
plugs into the 8-position jack on the tester has the potential to damage the outer-most contacts of the jack unless the plug is
specifi cally designed for that purpose.
WARNINGS:
Always wear approved eye protection.
Main Body (left to right)
RJ45 Port: data cable, ethernet cable, 8-wire cable, 4
twisted pair cable, Cat5e, Cat6, Cat6a, Cat7.
F-Connector Port: video cable, coaxial cable, RG6 cable,
RG59 cable.
RJ11/12 Port: phone cable, POTS (plain old telephone
service) cable, 4-wire cable, 6-wire cable, 2 twisted pair
cable, 3 twisted pair cable, Cat3.
VDV Scout Pro &
™
Instruction Manual
GENERAL SPECIFICATIONS
PORTS OVERVIEW
VDV Scout
™
The VDV Scout™ Pro LT combines these
• Maximum RJ Cable Length: 0 to 1000 feet (305 meters)
• Minimum Cable Length for Split Pair Detection:
1.5 feet (0.5 meters)
• Maximum Coax Cable Length: 100 ohms maximum DC
resistance, center conductor plus shield
• [LT] Length Measurement Method:
• [LT] Resolution:
• [LT] Length Measurement Range:
(610m) with 15pF/ft length constant (or 30nF total
capacitance)
• [LT] Length Accuracy (Without Length Constant
Accuracy): ±(5%+1ft) or ±(5%+0.5m)
• [LT] Length Constant Range:
(33pF/m to 132pF/m)
WARNINGS
WARNINGS:
Do NOT use on energized circuits.
Self-Storing Remote (left to right)
RJ11/12 Port
RJ45 Port
Use this remote to test
for continuity.
VDV Scout Pro: This remote Pro: This remote
TM TM TM
does not have an associated
ID number.
VDV Scout Pro LT: This remote has ID number 1.
TM
ID Remotes: (included in kit, or sold separately)
LANMap Remote (left): RJ45 connector.
CoaxMap Remote (right): F-connector.
Use these remotes to do cable
identifi cation mapping.
LANMap remotes cannot be
used to determine continuity.
Connectors:
Barrel Connector:
Female-to-female F-connector.
2
Pro LT
Capacitance
1 ft (0.5 m)
1 to 2000 feet
10pF/ft to 40pF/ft