Klein Tools VDV Scout Pro Mode D'emploi page 10

ENGLISH
T 5 6 8 A C a b l e w i t h S p l i t P a i r s :
T568A Cable with Split Pairs: A common error in building a cable is to put all the pairs in pin sequence 1-2, 3-4,
5-6 and 7-8. This will produce the correct continuity, but the pairs are designated to be on pins 3-6 and 4-5 in the
middle of the connector for compatibility with phone wiring. This wiring error is only detected by the split pair
test since the designated pairs are not twisted together.
T 5 6 8 A C a b l e w i t h a S h o r t a n d O p e n :
T568A Cable with a Short and an Open: The 1-2 pair pins are shorted together and the 7-8 pair is open. The pins
with the errors are flashing. Dash lines (-) on the bottom (remote) display line indicate the short, while no numbers
on the bottom line indicate the open pair.
T 5 6 8 A C a b l e w i t h a M i s w i r e a n d
U n r e c o g n i z e d C o n t i n u i t y :
T568A Cable with a miswire and unrecognized
continuity: 1 and 2 pins on the
connected to pins 2 and 1 at the remote-end. The pins with
this error are fl ashing. The "U" for the remote pin numbers
indicates an unrecognizable continuity was detected that
is neither a short or open. An ID remote connected to the
VDV Scout™ Pro
when in cable test mode would also
show this error.
C o a x C a b l e P r o p e r l y W i r e d :
Coax Cable Properly Wired with ID Remote #1: The #1
ID remote is used to terminate a properly wired coax
cable. The video test passes, ID #1 is detected, and the
"o"s across the bottom of the screen show that the tester
is running tests continuously.
WIRING AND DISPLAY EXAMPLES
VDV Scout™ Pro
are
10
FLASHING