Miele SLQL0 Mode D'emploi page 49

 Insert the supplied power supply plug
into the socket at the back of the
base station. You can wind excess
cable around the cable rewind. Guide
the cable through one of the two
cable runs (Fig. 06).
 Insert the country-specific power ad-
apter into the power supply until it
audibly engages and then plug it into
the selected power socket (Fig. 07).
Charging the rechargeable
battery (Fig. 08)
The rechargeable battery is supplied
not fully charged. Before using for the
first time, it must be fully charged while
the robot vacuum cleaner is switched
on (switch I/0 to I).
The battery can also be charged when
the robot vacuum cleaner is switched
off (switch I/0 to 0). In this case, the
vacuum cleaner indicators will not re-
act.
 Connect the robot vacuum cleaner
correctly to the charging contacts on
the connected base station.
As the rechargeable battery charges,
the status indicator flashes in the dis-
play.
The charging process takes up to
150 minutes for the Scout RX2 and up
to 180 minutes for the Scout RX2 Home
Vision.
You can then vacuum for up to one
hour with the Scout RX2 and up to two
hours with the Scout RX2 Home Vision.
Rechargeable battery status indic-
ator in the display
Red charged capacity approx.
0% - 20%
Orange charged capacity approx.
20% - 50%
Green charged capacity approx.
50% - 100%
Setting the time of day (Fig. 09)
You can choose between a 24 hour
clock and a 12 hour am/pm clock.
Use the remote control to set the time
of day.
 Briefly press the Clock button.
24h will appear in the display.
 Press the OK button if you want a 24
hour clock.
 Press the + button if you want a 12
hour am/pm clock and confirm 12h
with OK.
The hour display flashes in the indicator
field.
 Press the + or - direction button to
set the current hour.
 Press the OK button to confirm your
selection.
The minute display flashes in the indic-
ator field.
 Press the + or - direction button to
set the current minutes.
 Press the OK button to confirm your
selection.
en
49