Gaggenau VL 414 110 Notice De Montage page 12

Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Insert the control cable in the socket on the
appliance. The plug must engage.
2 Shorten the front clamp relative to the countertop
thickness Break the metal sheets off at the
.
predetermined breaking points.
Note: Make sure that you do not shorten it too
much, the clamping effect to the countertop must
be guaranteed.
12
Insert and align the appliance in the cutout
horizontally. Tighten the rear clamp using the screw
inside the appliance. Tighten the front clamp from
below .
Notes
‒ Do not overtighten the clamps, ensure that there
is a uniform seal gap on all sides.
‒ The rear clamp pivots out on its own during
tightening.
‒ The appliance must not be bonded to the
countertop with silicone.