Gaggenau VL 414 110 Notice De Montage page 10

Hole for control knobs
The built-in control panel can be integrated in the
bottom cupboard at drawer level. Panel thickness:
1" (16 - 26 mm)
1 As shown in the figure, produce the Ø 1
(35 mm) holes for fastening the control knobs in the
front of the bottom cupboard. A drilling template is
provided for exact positioning of the drill holes.
For flush installation:
10
2 If the front panel is more than 1" (26 mm) thick: mill
out the rear of the front panel so that it is no thicker
than 1" (26 mm). Choose the dimensions of the
/ " -
5
milled recess according to the control panel.
8
/ "
3
8
For flush installation: