dirna Bergstrom Bycool Compact 1.4 Instructions De Montage page 20

COMPACT
EN EN
Position the interior air distribution panel on the
11
front studs with (1) M6 wide-flanged washer
and (1) M6 nut on each stud. Tighten the nuts
until the foam duct comes up against the unit's
upper foam.
Take care to ensure the cables do not
become trapped between the duct and the
foam in the base of the unit.
11
EPDM
Gasket
Cabin roof
Upholstey
Tighten the nut in point 10a until it comes
12
up against the top part of the interior air
distribution panel.
12
EPDM
Gasket
Cabin roof
Upholstey
Place console and centre equipment in the
13
most convenient place of cabin roof. Once
centred, remove console for later installation.
Unit base
Nut M6
Stud M6
Unit base
Nut M6 (10a)
Nut M6
Stud M6
Rubber ductings
Rubber ductings
20
Air conditioning for vehicles
Foam
Interior air distribution
panel
Foam
Interior air distribution
panel