Inserting A Battery - Panasonic RR-US300 Mode D'emploi

Table des Matières

Publicité

Inserting a battery

Open the battery cover (
1 AAA LR03 battery (not supplied)
Make sure
and
are correctly oriented.
Close the battery cover
(
4
Use an alkaline battery.
6
Remove the battery from the unit when you will not
use the unit for a long period of time.
6
and
)
1
2
Battery
cover
and
)
5
The remaining battery level is indicated as shown
below while the unit is operating.
If the battery runs out, "
battery as soon as possible.
When the battery runs out of power, "
indicated and then the power turns off automatically.
Depending on the battery state and the operation to
be performed, even if the power turned off because
the battery ran out of power, the unit may be able to
be used for a while if it is turned on again. However,
the unit may suddenly turns off during operation due
to insufficient battery power.
A certain level of battery power is required to
delete files, format the unit ( ➜ page 11) and divide
files ( ➜ page 16). If any of these operations are
performed when the battery indicator is "
power will be turned off because the battery will run
out of power.
Turn the power off before removing the battery.
• If the battery is removed while the power is on,
data may be lost or the unit may be damaged.
Set the clock after inserting a battery for the first time
or replacing the battery. ( ➜ page 8)
Blinking
" blinks. Replace the
" is
", the

Publicité

Table des Matières
loading

Table des Matières