Constant Light Control - Niko 350-34001 Manuel Technique

4.8. Constant Light Control

Parameter Description
Switch-on brightness This is the value that is sent when the light is switched on.
setting
0-100%
Switch-off brightness This is the value that is sent when the light is switched off.
setting
0-100%
Lux level adjustment (10 – This parameter allows you to configure the light level at which the detector is switched on.
2000 lux)
# lux
Light intensity fluctuation Light intensity jumps below the set value will be ignored. Sensor hysteresis will compensate for these fluctuations.
compensation (hysteresis)
1-100%
Constant light control delay This is the time period before the dimming value is regulated in function of brightness level in the room.
hh:mm:ss
Switch-on lux adjustment With this parameter, you can activate the switch-on brightness: the detector will switch on when motion is detected and there is not enough brightness.
(0=Always ON, 2000 lux
# lux (0= Always ON, 2000 lux max)
max)
Switch-off delay With this parameter, you can configure the time period between the last motion detected and when the detector is switched off.
hh:mm:ss
Switch-off warning
Before fully switching off, the light is briefly dimmed to a minimum level to indicate that it will be switched off soon.
Disable
Enable
Warning time During this time frame, the light is dimmed to a minimum level before completely switching off.
hh:mm:ss
Warning brightness setting This is the warning brightness setting in day mode.
0-100%
Warning brightness setting This is the warning brightness setting in night mode.
(in night mode)
0-100%
Dimming steps This is the size of the dimming steps sent by the detector.
[50; 25%; 12.5%; 6.25%; 3.125%; 1.5625%]
Dimming speed This is the speed or interval at which the detector sends the dimming steps.
[1 ~ 255] (100 ms)
Switching / dimming mode This parameter enables objects that can be switched or dimmed manually.
selection via an external Default value: Disable
device
Disable
Enable
PM350-34x0x_EN
350-34001/350-34002/350-340X3/350-340X4/350-34902
If the brightness level remains below this value, the detector will switch on.
If the brightness level exceeds this value, the detector will switch off.
If the lux level remains below this value, the detector will switch on.
Light intensity jumps below this level will be ignored.
When this time frame has expired, the dimming value is regulated in function of brightness level in the room.
If the lux level remains below this value, the detector will switch on.
This is the time it takes for the detector to switch off after motion has been detected.
The light switches off directly.
The light first dims down to a minimum level before fully switching off.
The light is dimmed to a minimum level during the defined time period.
The light is dimmed at the set value before switch-off in day mode.
The light is dimmed at the set value before switch-off in night mode.
This is the size of the dimming steps.
This is the time between the dimmings steps.
No input objects are present.
Input objects are present.
9
EN