Hvac - Niko 350-34001 Manuel Technique

350-34001/350-34002/350-340X3/350-340X4/350-34902
Switch back to Automatic
Lock mode

4.9. HVAC

Parameter
Switch-off delay
Switch-on delay
Behaviour when motion is
detected
Behaviour after motion has
been detected
Repeat last command every
... (00:00:00= Disable)
Lock mode
10
EN
You can use this parameter to switch from Manual mode back to Automatic mode after the last motion or via object 22.
After motion
Object
With this parameter, you can activate a lock object to disable the channel.
Default value: Disable
Disable
Enable
Forced control
Description
With this parameter, you can configure the time period between the last motion detected and when the detector is switched off.
hh :mm :ss
With this parameter, you can set a time frame during which the detector will not switch on after motion has been detected.
hh :mm :ss
This parameter defines the output value of the detector when motion is detected.
Switch ON
Switch OFF
Do nothing
This parameter defines the output value the detector after motion has been detected.
Switch ON
Switch OFF
Do nothing
With this parameter, you can set the time period after which the last command needs to repeated.
hh:mm:ss
With this parameter, you can activate a lock object to disable the channel.
Default value: Disable
Disable
Enable
When motion is no longer detected, the detector will switch back to Automatic mode.
The detector will switch back to Automatic mode via object 22.
No lock object is shown.
The channel is enabled via the lock object.
The channel is disabled via the Forced control object and sends an ON or OFF.
This is the time it takes for the detector to switch off after motion has been detected.
An ON is sent after this time period if there is still motion detected.
When motion is detected, the detector sends a "1" to the output object.
When motion is detected, the detector sends a "0" to the output object.
When motion is detected, the detector sends nothing to the output object.
After motion has been detected, the detector sends a "1" to the output object.
After motion has been detected, the detector sends a "0" to the output object.
After motion has been detected, the detector sends nothing to the output object.
The detector will repeat the last command when the predefined time period has elapsed.
The HVAC channel is disabled.
The HVAC channel is enabled.
PM350-34x0x_EN