Operation - Bartscher 200069 Mode D'emploi

5.2 Operation

•
Before using the device, clean it in accorance with the instructions in
section 6 „Cleaning and descaling".
•
Pour the desired amount of water into the tank (up to the „MAX" mark).
•
When using the device, make sure it always contains a drinkable liquid.
The device must not hold any liquids unsuitable for drinking such as acids,
bases, oils, nitrates, etc.!
NOTE!
In order to shorten the water heating time, use warm water.
This helps save time and power!
•
Place the lid on the water tank and turn it clockwise to close the tank (bayonet lid).
•
Connect the device to a single grounded outlet.
•
Set the desired temperature between 30 ° C and 100 ° C using the temperature dial.
•
Switch the device on using the ON/OFF switch. The green power light will come on,
and remains on during the entire time of operation.
•
Immediately after changing the position of the temperature dial, the red heating light
will come on. Heating of water to the desired temperature starts at this moment.
•
After the set temperature is reached, the red heating light will go off. Set the
temperature dial in the position for maintaining the water temperature.
•
If the temperature inside the tank drops, the thermostat will activate the device
and the red heating light will come on.
•
Hot water can be used to prepare various beverages (tea, insant coffee, instant
soup, etc.).
•
When preparing e.g. a tea, remember that various types of tea brew best at different
temperatures. Follow the manufacturer's instructions on the tea package.
- 29 -