Bartscher 200069 Mode D'emploi page 31

• To pour hot water, place an appropriate
container (glass, cup or mug) under the
drain tap. Press the tap lever down and
hold it unti the desired amount of water is
poured.
When finished pouring, release the tap
lever and the tap will close automatically.
•
During operation of the device, monitor the water tank's level by observing the
filling level indicator.
CAUTION!
Monitor the water level regularly and add water as needed.
Never operate the device without water!
•
Before filling in the tank or adding water, switch the device off.
•
Then carefully remove the lid and add the desired amount of water. When using the
device, touch only the handles and switches designed for this purpose.
•
After you have finished using the device, turn the temperature dial to the „OFF"
position by turning it counterclockwise, then switch the device off using ON/OFF switch
and remove its plug from the socket.
•
Wait for any remaining water in the tank to cool off, then pour it into another
container using the drain tap.
The device is equipped with an overheating/dry heating protection function. If
the device is accidentally switched on with too little or no water, this protection will
be activated and the device will switch off automatically.
Disconnect the device from the socket (pull the plug!) and wait for it to cool off.
After cooling, empty the water tank and press the
RESET button at the bottom of the device.
The device can be later filled with fresh water
and used again.
- 30 -