Disabling The Toilet For Cleaning Operations; Disabling The Toilet For A Shower; Programming The Backlight - Thetford Marine TECMA Compact Line Manuel D'installation Et D'utilisation

Disabling the toilet for cleaning operations.

Temporarily disable the buttons in order to clean the Touch control panel.
1. Place your hand on the panel for 15 seconds without touch it.
2. The backlight starts blinking for 3 sec.
3. Remove the hand.
4. Clean the panel with a cloth.
5. The buttons will be automatically enabled again after 15 seconds.

Disabling the toilet for a shower

In case the Touch SFT Multifunction is installed in the shower, temporary disable the buttons
in order to avoid it to be accidentally activated by water spread
1. Place your hand on the panel for 15 seconds without touch it.
2. The backlight starts blinking for 3 sec.
3. Press the central area at the tank LED.
4. All LEDs will flash to confirm command.
5. The backlight will start to blink slowly.
6. The buttons will be automatically enabled again after 15 minutes.
Programming the back led light
You can program the Touch panel to have the backlight:
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Compact line | Installation and use manual | ENG
54
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com