Thetford Marine TECMA Compact Line Manuel D'installation Et D'utilisation page 41

Needed to complete toilet installation:
Water Supply Kits (one kit required)
12V or 24V Raw Water Pump Kit
■
12V or 24V Solenoid Valve
■
Raw Water Fitting Kit
■
Plumbing Components
In-line Strainer
■
3/4"-diameter minimum Vented Loop – if required
■
1-1/2"-diameter minimum Vented Loop – if required
■
3/4"-diameter Marine Water Supply Hose
■
1-1/2"-diameter Marine Discharge Hose
■
1-1/2" straight coupling (as needed)
■
1-1/2" 90° coupling (as needed)
■
Electrical Components
Wiring to toilet system power
■
Wiring to Full Tank Sensor
■
Wiring to Optional Tank Mid-Level Sensor
■
Wiring from electronic controller to water pump (raw water installations)
■
Wiring Harness Connectors (Model Dependant)
■
Supplies
Silicone caulk (white or clear)
■
NOTE: To install the Tecma toilet, it is necessary to have a toilet, a control panel and
a water inlet system (see appendix).
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Compact line | Installation and use manual | ENG
41
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com