Disabling The Toilet For Cleaning Operations; Disabling The Toilet For A Shower - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

Disabling the toilet for cleaning operations.

Temporarily disable the buttons in order to clean the Touch control panel.
1. Place your hand on the panel for 15 seconds without touch it.
2. The backlight starts blinking for 3 sec.
3. Take your hand away.
4. Clean the panel with a cloth.
5. The buttons will be automatically enabled again after 15 seconds.

Disabling the toilet for a shower

Nel caso in cui il pannello Touch fosse all'interno della doccia, per evitare attivazioni
involontarie legate agli schizzi d'acqua, è possibile disabilitare temporaneamente i pulsanti.
1. Place your hand on the panel for 15 seconds without touch it.
2. The backlight starts blinking for 3 sec.
3. Press the central area at the tank LED.
4. All LEDs will flash to confirm command.
5. The backlight will start to blink slowly.
6. The buttons will be automatically enabled again after 15 minutes.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
51
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com