Floor Fixation - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

3.2

Floor fixation

The floor fixation of each head of Flexi Line and Design is using nylon brackets with side
screws and floor anchors (excluding Xlight and Evolution with special mounting kit).
Each toilet is provided with a template with the measures for drilling to the floor. In the
specific case of the new Flexi 2G line (excluding Elegance CUT), the template reverse side is
a scaled template to easily locate the exact location for drilling to the floor.
The installation of the Flexi 2G line is completed in a few steps as described below:
• Place the template against the wall in a central position to the final position of the
WC
• Drill the floor in the drilling points scored in scale on the template for all Flexi 2G
models (except Elegance CUT)
• Fasten the screws to the brackets and place the toilet.
• Secure with the side fastening screws. Horizontal screw tightening must be made
with a maximum torque of 2.5 Nm.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
58
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com