JUKI LK-1942ZA5050 Manuel D'utilisation page 56

(3) Setting of the scale
Setting of the X scale
PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP
Setting of the Y scale
PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP
(4) Setting of the max. sewing speed limitation
PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP
(5) Finish of setting
Use after checking the pattern No. Press the sewing ready switch while No. other than
the service pattern is indicated on the display, and the error No. E-1 will be shown. At this
time, set again the pattern No. which has been registered.
Press key at least four seconds after having turned ON the sewing machine. If you
press the key earlier, error display E-5 will be displayed. If this error is displayed, reset the
error display by pressing
1) Press the
Scale".
2) Press the
range of 20% to 200%.
1) Press the
Scale".
2) Press the
range of 20% to 200%.
1) Press the
2) Press the
the display. (Setting of 400 sti/min)
1) Press the
2) The feeding frame comes down and moves.
Then, after it has been raised, the sewing LED
lights up, and the sewing is ready.
SEWING
* If the
the set value of the respective items again.
key again.
– 8 –
key to indicate the item "X
or key to set the scale in the
key to indicate the item "Y
or key to set the scale in the
Enlargement/reduction is a mode
of enlargement/reduction of stitch
length. When enlargement/reduction
is performed, the number of stitches
is fixed and the stitch length varies.
key to indicate the item "Speed".
or key to indicate "
key.
key is pressed, you can make sure
"on