Operation Of The Device; Item Data Setting - JUKI LK-1942ZA5050 Manuel D'utilisation

V. OPERATION OF THE DEVICE

1. Item data setting

Set each item following the procedure described below.
Switch design on the control box may be different from each other in accordance with the models.
Setting of the Setting of the X
pattern No. scale
(1) Turn ON the power switch
PATTERN No. of the item selection lights up, and the pattern No. is indicated on the data display.
(2) Setting of the pattern No.
PATTERN No.
X-SCALE
Y-SCALE
SPEED
COUNTER
WINDER
THREAD
CUTTER TEMP
Service pattern
No.
□ 50×30 mm
P=3.0
P=3.0 ø30
P=3.0
P=3.5 ø30
P=3.0
Sewing cannot be performed
since this No. is for the pattern
for adjusting the amount of oil in
the hook.
Setting of the Y
scale
1) Press the
2) Press the
In case the pattern is not prepared, indicate the
service pattern No. 55 inputted beforehand at the
time of delivery. Since the intermediate presser is not
provided, prepare the feeding frame which matches
the sewing pattern.
The needle thread heat cutter only operates when
Shape
the sewing pattern selected is Pattern No. 55.
Refer to "4. Notes on creating a sewing pattern"
for details.
– 7 –
Setting of the
max. sewing
speed limitation
key to indicate the item "PAT-
TERN No.".
or key to indicate Pattern
No. 1 to 99 on the display.