Konig & Meyer Omega-E Mode D'emploi page 115

Display
The DPG1C has one OLED display, which indicates the height
while the keyboard table is in motion as well as many other
texts for user guidance.
Setting the starting height of the keyboard table.
If the height shown in the display is not correct, the height can
be set. Press the "Reminder" and "Bluetooth®" button on the
DPG1C simultaneously for 5 seconds; the height in the display
will begin to flash. If you press the DPG1C, the height in the
display will change without moving the keyboard table. Press
the DPG1C upwards to increase the height; press the DPG1C
downwards to decrease the height indicated in the display.
Press any key to confirm the selection, or wait 10 seconds and
it will be confirmed automatically.
Switching between centimeters and inches
Press the "Memory" and "Bluetooth®" button on the DPG1C
simultaneously for 5 seconds; the current measurement unit
will flash. For example, if CM is flashing and the user would like
to switch to inches, press the DPG1C once. Now "Inch" will be
shown in the display. Press any key to confirm the selection or
wait 10 seconds and it will be confirmed automatically.
Error codes
The DPG1C will display error codes in the event of a system
error. The error codes (EXX) and their cause can be found in a
table in the appendix.
Table-style keyboard stand »Omega-E«
Item no.: 18800-000-55 / 18800-010-55
Starting operation /operation
5
Set table
height
Set
centimeters
and inches
Error codes
30