Konig & Meyer Omega-E Mode D'emploi page 107

5. Starting operation/operation
Observe the safety chapter
IMPORTANT
Observe the basic safety instructions in Chapter 2, "Safety in-
structions".
5.1 Commissioning
Caution Independently of the load, the switch-on duration of 10 %
(~ 6 min. / hour) or a max. of 2 min. of continuous op-
eration may not be exceeded, as this will lead to overheating
of the motor and the control unit.
After 2 min. of continuous operation, the keyboard stand
must cool down for 18 min.
Exceeding the switch-on duration can significantly shorten the
service life of the keyboard table.
Before starting operation
Ü
Ü
Ü
Ü
Ü
Ü
During operation
Table-style keyboard stand »Omega-E«
Item no.: 18800-000-55 / 18800-010-55
Starting operation /operation
Check the keyboard table and all associated electrical
and mechanical components for damage!
Ensure that the system has been installed in accord-
ance with the assembly instructions.
Also ensure that the voltage at the power adapter is
correct before the system is connected to the power
supply.
The individual system elements must be interconnected
before the power adapter is connected to the power
supply.
The keyboard table may require initialization. (To ini-
tialize the keyboard table, move it completely down. To
do so, press the control element downwards and hold it
pressed until the movement has been completed. Then
press the control element downwards again and hold it
(approx. 5 seconds) until the keyboard table has made
a slight movement downwards and then upwards again.
Only let the element go once the keyboard table is no
longer moving. If you let go too early, it will lead to a
malfunction. If this occurs by accident, you must repeat
the process.)
Before using the keyboard table, the table height must
be set. (For instructions, see the "Control panel" chap-
ter)
5
General
information
General
Starting
operation
22