Konig & Meyer Omega-E Mode D'emploi page 102

Ü
The master column must be on the side of the control panel!
IMPORTANT
Ü
Table-style keyboard stand »Omega-E«
Item no.: 18800-000-55 / 18800-010-55
B
Fasten the master and slave columns with the
transverse bar. To do so, lift the 1st side of the trans-
verse bar (e.g. with a 2nd person or by placing it on a
chair) à Lift the 2nd side and slide in the column à
screw the column onto the transverse bar with the Allen
key provided (tightening torque max. 7.5 Nm - careful
when placing the screws). Slide in the 2nd column and
fasten.
C
Mount the supports on the transverse bar.
To do so, insert the carriage bolt through the support
from above à Put the carriage bolt through the hole in
the transverse bar depending on the keyboard size and
place the support (long side must be on the side of the
control panel) à Push the washer onto the bolt à
Screw in the clamping nut.
Assembly
B
C
3
17