Konig & Meyer Omega-E Mode D'emploi page 114

sitting position, the light bar pulses in green until the reminder
goes out again.
After 4 hours without any action, the light bar goes out. If the
DPG1C is pressed, the green light switches back on.
Please note that when the light bar for reminders is activated,
the DPG1C is no longer in ZERO mode as long as the light is
switched on / active.
Figure 4: A pulsing green light bar indicates that there is no problem.
Figure 5: A pulsing orange light bar indicates that the user must change posi-
tions.
Factory default
Pressing and holding the "Memory" and "Reminder" buttons for
8 seconds resets the DPG1C to the factory default. The light
bar will flash red three times. If the device is reset to the fac-
tory default, the DPG1C is reset to the configured state. This
does not mean that all the configurations made in the DPG1C
configurator are reset – only those settings that have been
modified by the end user directly on the DPG1C or in the app
are deleted.
Table-style keyboard stand »Omega-E«
Item no.: 18800-000-55 / 18800-010-55
Starting operation /operation
5
Factory
default
Display
29