dirna Bergstrom bycool FLAT Instructions De Montage page 25

FLAT
15
Place console and centre equipment in the most
convenient place of cabin roof. Once centred, re-
move console for later installation.
16
Fasten the fastening supports by tightening the
nut until the outer EPDM seal tightening of the
equipment is between 3 and 6mm.
Important: To avoid possible water leaks into the
inside of the cab the EPDM seal tightening must be
adjusted with the base of the Bycool as indicated
in the drawing.
3-6mm.
Cab roof
Tighten the nuts until the
seal tightening of the rubber
is between 3 and 6 mm.
17 Screw (4) M8 nuts to the support and (4) to the
base of the Bycool.
EPDM seal
10 mm*
(*) (approx. after tightening)
Base
Support
17
25
Check compression
thickness using a
tape measure in the
four corners.
EPDM seal
EN
®
15
16
16