Bosch 800 Série Notice D'installation page 15

9
a
c
A
• Attach an approved strain relief (not provided) to opposite side of
junction box.
• Without adjusting the terminal screws, insert the wires properly in the
terminal. Make sure that the black wire connects with the black (L)
and the white connects with the white (N) and the green or bare cop-
per wire with the green (G or
• Do NOT insert wire underneath the screw clamp. (see box a)
• Be certain the wire insulation is not trapped in the terminal. 1-2 mm of
wire must be visible (See box b)
• After inserting wire, completely tighten the terminal screws by turning
clockwise. (See box c)
• After tightening the terminal screws, pull on each wire to ensure that
they are secure. Wire should not be loose in the terminal after correct
installation.
• Secure the wire in the junction box with the strain relief.
Note: The arrow (shown in box d above) should align with the power
cord.
strain relief
). (See box b)
b
white (N)
black (L)
1-2 mm
d
ADVERTENCIA
ESTRICTAMENTE SIGA TODAS LAS INSTRUCCIONES DE ESTE MANUAL.
UTILICE SÓLO EL 14 O 12 DE ALAMBRE DE COBRE AWG CON UN GRADO
DE LA TEMPERATURA MÍNIMA DE 75 ° C (167 ° F).
COLOQUE TODOS LOS CABLES EN LA CAJA DE LA FUENTE DE ALIMEN-
TACIÓN Y LA INSTALACIÓN DE LA CUBIERTA. TORNILLOS DE CONEXIÓN
NO SON EXTRAIBLES.
1/2" (13 mm)
WIRE STRIP GAGE
CALIBRE DE POUR DÉNUDER
INDICADOR DE CABLE PELADO
WARNING
STRICTLY FOLLOW ALL INSTRUCTIONS IN THIS MANUAL.
USE ONLY 14 OR 12 AWG COPPER WIRE WITH A MIN. TEMP. RATING
OF 75°C (167°F).
PLACE ALL WIRING IN THE POWER SUPPLY BOX AND INSTALL COVER.
CONNECTION SCREWS ARE NOT REMOVABLE.
AVERTISSEMENT
OBSERVER TOUTES LES INSTRUCTIONS DE CE GUIDE.
UTILISER SEULEMENT DU FIL DE CUIVRE 14 OU 12 AWG AVEC UNE
COTE DE TEMPÉRATURE MINIMALE DE 75°C (167°F).
PLACER TOUS LES FILS DANS LA BOÌTE D'ALIMENTATION ET
REMETTRE LE COUVERCLE.
LES VIS DE CONNEXIONS NE SONT PAS AMOVIBLES.
view with cover installed
green (G)
arrow
15