Bosch PSR 960 Instructions D'emploi page 8

EURO • Printed in Malaysia • BA 2 609 140 186 • PSR 960-1440 • GB • OSW 02.02
2 609 140 186.book Seite 2 Donnerstag, 7. Februar 2002 3:14 15
Hold the machine tightly: When driving in
screws, high reaction moments can briefly oc-
cur.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
Battery and Battery Charger
The enclosed operating instructions for the
battery charger must be read carefully!
The battery and battery charger are designed
to match each other. When charging the bat-
tery, use only a Bosch battery charger de-
signed for it with a charging voltage that corre-
sponds with the battery (see type plate). Com-
bining different rated voltages causes damage
to the battery charger.
Allow a heated battery to cool before charging.
Protect the battery from heat and fire: Danger
of explosion! Do not place the battery on radi-
ators or expose to strong sun rays for a longer
time; temperatures over 50 °C cause damage.
Do not open the battery, and protect it from im-
pact. Store in a dry and frost-free place.
Cover the contacts of a removed battery. Dan-
ger of fire results when shorted by a metal ob-
ject!
Do not throw the battery into the household
waste, into fire or water.
Before Putting into Operation
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approximately 5 charging/discharging
cycles.
To remove the battery 5, press the unlocking but-
tons 6 and pull out the battery downwards. Do not
exert any force.
The battery is equipped with an NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C.
A long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the batteries are used and
must be replaced.
Observe the notes on environmental protec-
tion.
8 • 2 609 140 186 • TMS • 01.02.02
Changing the Tool
Open the drill chuck until the tool can be inserted.
Insert the tool.
Hold the rear collar tight and firmly tighten the
front collar by hand, until the "clicking" of the lock-
ing action is no longer heard. This automatically
locks the chuck.
The locking is released again when the front col-
lar is turned in the opposite direction to remove
the tool.
Screwdriving (see figures
Directly clamp the screwdriver bit into the drill
chuck or use the additional universal bit holder 8
when operating with hex shank bits 7.
Initial Operation
Inserting the Battery
Set the rotational direction switch 3 to the centre
position = lock-off and allow the charged bat-
tery 5 to engage into the handle.
Switching On and Off
To start the machine press the On/Off switch 4.
The machine runs with variable
speed between 0 and maximum,
depending on the pressure applied
to the On/Off switch 4. Light pres-
sure results in a low rotational
speed thus allowing smooth, con-
trolled starts. Do not strain the ma-
chine so heavily that it comes to a
standstill.
To switch off the machine, release the On/Off
switch 4.
English - 2
+ )
A B