AYA ATV3F Instructions D'utilisation page 47

Some pans make
crackling or clicking
noises.
8. Installation
8.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the
hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and
insulated work surface material (Wood and similar fibrous or hygroscopic material shall not be
used as work surface material unless impregnated) to avoid the electrical shock and larger
deformation caused by the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the
worktop should be at least 3mm.
H
D
X
B
L(mm) W(mm) H(mm) D(mm) A(mm) B(mm) X(mm)
590 520
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet
and outlet are not blocked. Ensure the ceramic cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate
should be at least 760mm.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
L
X
55 51 560+4
W
A
X
490+4 50 mini 3 mini
+1 +1
EN-19
This is normal for cookware and
does not indicate a fault.
X
Mini.3mm
F(mm)
F