Repair; Disposal / Recycling - Eaton CROUSE-HINDS Série Mode D'emploi

7.2 Test of the emergency light function
Switch the luminaire off the mains voltage.
The emergency lamp (green lampholder) must light.
Mind: The emergency function takes at least 1 min.
A function test should not exceed the following test periods:
Battery set for 1.5 h emergency light: 60 min.
Battery set for 3.0 h emergency light: 120 min.
Please refer to the enclosed supplement to the Operating instructions for
further information.
Mind: The full battery capacity will be available after approx.
3 charging/discharging cycles due to physical behaviour.
Fault analysis: eLLK92 NI / NE; eLLB 20 Ni / NE; eLLS08 NE
(Test during continuous switching of light fitting - combinations with several faults are not registered)
Operating status
Normal operation Mains operation
No fault Emerg. operation
Mains operation
EVG fault
Emerg. operation
Mains operation
VE fault
Emerg. operation
Mains operation
Battery fault
Emerg. operation
* = see Operating Instructions for LED - functions
1) = reduced luminous flux
2) = lamp off or only in operation for a few seconds
12
Explosion protected emergency light fittings Series:
eLLK 92 NE, eLLM 92 NE, eLLS 08 NE
Operation Operation
mains lamp emerg. lamp
on on
off on 1)
off off
off on 1)
on off
off off
on on
off off 2)
8.

Repair

Prior to replacing or removing any components, observe the
following:
Cut the apparatus off the voltage before opening or servicing it!
Only use certified genuine (CCH / EATON) spare parts!
(See CCH / EATON spare parts list).
9.

Disposal / Recycling

When the apparatus is disposed of, the respective national regulations on
waste disposal will have to be observed.
In case of disposal you can obtain additional information from your Cooper
Crouse-Hinds / EATON branch.
Subject to modifications or supplement of the product range.
EVG - VE -
function function
ok ok
ok ok
faulty ok
faulty ok
ok faulty
ok faulty
ok ok
ok ok
GB
Battery *
ok
ok
ok
ok
ok
ok
faulty
faulty