Christopeit Sport TE 1 Notice De Montage Et D'utilisation page 12

Assembly Instructions
Before beginning assembly, be sure to observe our
recommendations and safety instructions. Some parts are
pre assembled.
Step 1:
Fold out the exercise equipment.
1. Remove the pre-assembled unit from packaging and put it with foot
caps (13+14) on the floor.
2. Fold out the pre-assembled unit a little bit for the first step like arrow 1
shows.
3. Pull out the unlock pin (41) and go on with folding out with rear foot
(3) as arrow 2 shows. Only by pulling out unlock pin (41) you can fold out
completely the exercise equipment.
(Attention: Folding in and out the TE 1 needs special attention and
very carefully move, because of squeezing danger. If necessary ask
a 2nd person for help.)
Step 2:
Attach the free weight bar (49) and foot support (6).
1. Attach the free weight bars (49) on both sides of the roller slide (7)
by using screws (51), washers (23) and nuts (24).
2. Slide on the spring clamps (50) onto the free weight bars (49) to secure
optionally weight disks.
3. Put the foot support (6) into the appropriate holder of front foot (1) and
secure position with locking pin 1 (17).
(Note: It depends on the exercise if the foot support (6) is assembled
or not. If you do exercise with foot support (6) you have to secure the
position with locking pin 1 (17), because of safety reasons.)
12