Fuse Replacement; Safety Functions; Reverse Gear Buzzer; Hopper Lifting/Lowering Lever Safety Flange - Nilfisk Advance RS 500 Instructions D'utilisation

INSTRUCTIONS FOR USE

FUSE REPLACEMENT

1. Engage the parking brake (7, Fig. E).
2. Turn the ignition key (17, Fig. D) counterclockwise, to the
end of stroke, then remove it.
3. Remove the transparent cover of the fuse box (24 or 25,
Fig. D) and replace the relevant fuse:
Fuse box B (24, Fig. D)
a. Hazard warning light fuse (10 A)
b. Brake lights/horn fuse (10 A)
c. Left side running light fuse (10 A)
d. Right side running light fuse (10 A)
e. Low beam fuse (15 A)
f. High beam fuse (15 A)
g. Free fuse holder
h. Free fuse holder
Fuse box A (25, Fig. D)
i. Hydraulic system oil cooler fan/skirt solenoid valve
fuse (20 A)
j. Fuel solenoid valve fuse (10 A)
k. Cab blower/flashing light/windscreen wiper fuse (15
A)
l. Dust control system water pump fuse (10 A)
Dust control system water pump/climate control
system fuse (20 A)
m. Reverse gear buzzer fuse (10 A)
n. Warning lights/glow plug control unit fuse (10 A)
o. Electric jack warning light fuse (10 A)
p. Hopper door opening/closing electric jack fuse (15 A)
4. Install the transparent cover of the fuse box (24 or 25,
Fig. D).
28

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.

REVERSE GEAR BUZZER

The machine is equipped with a sensor and a buzzer to
indicate that the machine is moving in reverse.
HOPPER LIFTING/LOWERING LEVER SAFETY
FLANGE
The hopper lifting/lowering lever can be activated only after
having lifted the safety flange.
SUCTION INLET AND BROOM
LIFTING/LOWERING LEVER SAFETY FLANGE
The suction inlet and broom lifting/lowering lever can be
activated only after having lifted the safety flange.
SENSOR FOR ENGINE START-UP INHIBITION
WHEN THE DRIVE PEDAL IS PRESSED
The machine is equipped with a sensor that do not allow for
engine start up when the drive pedal is pressed.
33015122(1)2006-02