Electrical Fuses; Accessories/Options - Nilfisk Advance RS 500 Instructions D'utilisation

10. Skirt cylinder
11. Hopper lifting cylinder
12. Hand pump
13. Right broom motor
14. Left broom motor
15. Hydraulic system oil cooler
16. Parachute valve
17. Suction inlet and broom lifting cylinder
18. Check valve
19. Power steering
20. Flow separator (priority valve)
21. Accessory and power steering pump
22. Suction fan pump
23. Distributor
24. Solenoid valve
25. Suction fan motor
26. Hydraulic power steering cylinder
27. Drive pedal assist
28. Oil filter
29. Drive system pump oil filter
30. High-pressure washing system pump (*)
(*) Optional for some countries.

ELECTRICAL FUSES

At the left side of the control panel there are two fuse boxes
(24 and 25, Fig. D), with a transparent cover, containing the
following fuses:
Fuse box B (24, Fig. D)
a. Hazard warning light fuse (10 A)
b. Brake lights/horn fuse (10 A)
c. Left side running light fuse (10 A)
d. Right side running light fuse (10 A)
e. Low beam fuse (15 A)
f. High beam fuse (15 A)
g. Free fuse holder
h. Free fuse holder
33015122(1)2006-02
INSTRUCTIONS FOR USE
Fuse box A (25, Fig. D)
i. Hydraulic system oil cooler fan/skirt solenoid valve
fuse (20 A)
j. Fuel solenoid valve fuse (10 A)
k. Cab blower/flashing light/windscreen wiper fuse (15
A)
l. Dust control system water pump fuse (10 A)
Dust control system water pump/climate control
system fuse (20 A)
m. Reverse gear buzzer fuse (10 A)
n. Warning lights/glow plug control unit fuse (10 A)
o. Electric jack warning light fuse (10 A)
p. Hopper door opening/closing electric jack fuse (15 A)

ACCESSORIES/OPTIONS

In addition to the standard components, the machine can be
equipped with the following accessories/options, according to
the machine specific use:
– Brooms with harder and softer bristles
– High-pressure washing system (*)(**)
– Audio unit kit
– Cab climate control system (*)(**)
– Rear suction pipe (*)(**)
– Driver's seat safety belt (*)(**)
(*) Optional for some countries.
(**) In order to use these accessories, the sweeper must be
equipped with the appropriate fittings.
11