The Set Setting Menu - Sony VPL-CS5 Mode D'emploi

About the Preset Memory No.
This projector has 38 types of preset data for
input signals (the preset memory). When a
preset signal is input, the projector
automatically detects the signal type and
recalls the data for the signal from the preset
memory to adjust it to an optimum picture.
The memory number and signal type of that
signal are displayed in the INFORMATION
menu (See page 35). You can also adjust the
preset data through the INPUT SETTING
menu.
This projector has 20 types of user memories
for INPUT-A into which you can save the
setting of the adjusted data for an unpreset
input signal.
When an unpreset signal is input for the first
time, a memory number is displayed as 0.
When you adjust the data of the signal in the
INPUT SETTING menu, it will be
registered to the projector. If more than 20
user memories are registered, the newest
memory always overwrites the oldest one.
See the chart on page 46 to find if the signal
is registered to the preset memory.
Since the data is recalled from the preset
memory about the following signals, you
can use these preset data by adjusting "H
Size." Make fine adjustment by adjusting
"Shift."
Signal Memory No. SIZE
Super Mac-2 23
SGI-1 23
Macintosh 19" 25
The following are for the VPL-CX5 only.
Macintosh 21" 27
Sony News 36
PC-9821 36
1280 × 1024
WS Sunmicro 37
Note
When the aspect ratio of input signal is other
than 4:3, a part of the screen is displayed in
black.
32
GB

The SET SETTING Menu

The SET SETTING
Menu
The SET SETTING menu is used for
changing the settings of the projector.
SET SETTING
Menu Items
Smart APA
Activates or deactivates the Smart APA
On: Normally select this setting. When a
signal is input from a computer, the APA
functions automatically so that the
picture can be seen clearly. Once the
specified input signal has been adjusted
by the Smart APA, it will not be
readjusted even when the cable is
disconnected and connected again or the
input channel is changed. You can adjust
the picture by pressing APA key on the
1312
Remote Commander even if the Smart
APA set to "On."
1320
Off: The APA functions when you press the
1328
APA key on the Remote Commander.
1456
1) The APA (Auto Pixel Alignment)
automatically adjusts "Dot Phase," "H Size"
1708
and "Shift" in the INPUT SETTING menu
1600
for the input signal from a computer.
1664
Auto Input Search
Normally set to "Off."
When set to "On," the projector detects input
signals in the following order: Input-A/
MS(VPL-CX5 only)/Video/S-Video. It
Input A
S m a r t A PA : O n
Auto Input Search: O f f
Input-A Signal Sel.: C o m p u t e r
C o l o r S y s t e m : Au t o
Pow e r S av i n g : O n
1)
.