The Install Setting Menu - Sony VPL-CS5 Mode D'emploi

The INSTALL
SETTING Menu
The INSTALL SETTING menu is used for
changing the settings of the projector.
INSTALL SETTING
T i l t . . .
V Key s t o n e : Au t o
I m ag e F l i p : O f f
B a ck g ro u n d : B l u e
L a m p M o d e : L ow
Menu Items
Tilt...
Adjusts the position (height) of the projected
picture. Pressing the f on the TILT
adjustment key or M/, key on the Remote
Commander, the more the projector tilts and
the higher the position of the picture.
Pressing the F on the TILT adjustment key
or m/< key on the Remote Commander,
the less the projector tilts and the lower the
position of the picture.
V Keystone
Corrects the trapezoidal distortion caused by
the projection angle. Select "Auto" for
automatic correction, or "Manual" for
manual correction using the < or , key.
When the bottom of the trapezoid is
longer than the top
value.
When the top of the trapezoid is longer
than the bottom
value.
Note
The auto V Keystone adjustment may not
correct the trapezoidal distortion perfectly,
depending on the room temperature or the
screen angle.
34
GB

The INSTALL SETTING Menu

Input A
: Sets a lower
: Sets a higher
Image Flip
Flips the image on the screen horizontally
and/or vertically.
Off: The image does not flip.
HV: Flips the image horizontally and
vertically.
H: Flips the image horizontally.
V: Flips the image vertically.
Note
When the Image Flip is set to "HV" or "V",
the Lamp Mode works with "Low" setting.
Background
Select the background color of the screen
when no signal is input to the projector.
Select black or blue.
Normally set to "blue."
Lamp Mode
Sets the lamp brightness in the projection.
High: Illuminates the projected image
brightly.
Low: Reduces fan noise and power
consumption. The brightness of the
projected image will be lower compared
with the "High" setting.