Publicité
Les langues disponibles
Les langues disponibles
EN
After cleaning, install the filters back to the filling hose and into the threaded branch pipe of the electric
valve in the reverse order. Connect the filling hose and check the tightness of connections – they should
be dry, when Machine works.
CLEANING THE PUMP FILTER
Prior to start cleaning the filter, check for any water present in the drum.
It is recommended to clean the filter once a month and after every washing of longnap items.
Prior to cleaning, drain off the water remaining in the filter. Open the lid of filter 1 (Fig. 22) with the help
of a screwdriver, coin or some other sharpened piece. Draw hose 2 (Fig. 23) out of the Machine and put some
vessel to collect the water. Take plug 1 out of hose 2 and drain the water down into the vessel. Turn the filter
handle 4 contraclockwise (Fig. 23) and take the filter out.
ATTENTION! Residual water may leak out when filter handle is rotated.
Remove any rubbish out of the filter and clean it by a water jet.
Insert the plug into the hose and the filter into its place in the reverse order. Check the correct position
and clamping of the filter. Close the lid of filter 3.
8 SAFETY REQUIREMENTS
When handling and transporting the Machine, observe safety precautions since the Machine is
rather heavy in weight.
ATTENTION! Never use the Machine as a support, pedestal, etc.
NEVER place the Machine outdoors, where it may be exposed to weather conditions.
NEVER operate the Machine without plastic plugs installed as required.
Prior to connect the Machine to the electric mains, examine visually the power cord for absence
of damage. The cord should not overbend or get pinched.
For safety reasons, a damaged power cord should be replaced for a new one by the manufacturer
or a repair service.
The Machine is not designed for use by handicapped persons (including children), people having
degraded sensorial and mental abilities, and with insufficient experience and incomplete knowledge
also, in case if above persons are not under supervision, or do not receive instructions from persons
responsible for their safety. Keep your Machine away from use in children games.
To ensure electric and fire safety, NEVER:
- connect the Machine to the electric mains with defective overcorrect protection facilities;
- connect the Machine by means of a socket without a grounding contact;
- connect the Machine to the electric mains by means of adapters, multioutput sockets (with two
and more connection outputs) and/or cord extensions;
- insert the plug in and out of the socket with wet hands;
- touch the Machine with wet hands;
- wash the Machine with a water spray;
- pull the power cord to disconnect the Machine from the electric mains;
- make any unauthorized repairs and changes of the Machine design, its water and electric sup-
plies, which may result in a serious damage of the Machine and cancel the warranties. The Machine
should be only repaired by a qualified specialist of the repair service.
ATTENTION! In case of a failure of the Machine or detection of a malfunction, disconnect the
Machine from the electric mains, cut water supply and call up a service specialist.
Please, use the new filling hose only by fixing to the cold water supply system.
NEVER let children operate the Machine.
To escape an explosion risk, NEVER use washing substances containing solvents.
During the washing cycle, it is recommended not to touch the door of the Machine, since it gets
hot and may cause a burn.
Bipolar grounding receptacle for power supply of machine should be installed in place which is
accessible for immediate shutting down the machine from electrical network.
After the washing cycle, set the Wash Program Selector Knob to the mark
Machine from the electric mains, having taken the plug out of the socket and shut off the water supply.
46
(Fig. 4), disconnect the
Publicité
