Publicité
Les langues disponibles
Les langues disponibles
EN
Additional rinse
The function is provided for washing children's clothes, items of people, who are detergent
allergic, or for washing in a very soft water, in which a detergent is rinsed insufficiently. When the
function is included into the Wash Program, one more rinse will be added.
Light press
he function is provided to reduce the creasing level of fabrics during washing and spinning
and to ease subsequent ironing. The function ensures a delicate washing mode and careful spinning
with minimum number of wrinkles after washing.
Stop with water in the tank
The function is used, when items of a fine texture are washed, and when there is no possibil-
ity to take items from the Machine immediately after washing, not to get them crumpled. When
the function is switched on, the Machine will stop automatically after the last rinse (before water drain).
ANTI-CLOSING DOOR BLOCKING
The anti-closing door blocking prevents from accidental Machine operation, for example, by children.
To lock the door, turn the lock (Fig. 5) by a screwdriver clockwise up against the stop – the lock will move
forward and prevent to close the door. To cancel the locking before washing, perform all the actions in the
reverse sequence.
3 PREPARATION FOR OPERATION
PREPARATION FOR INSTALLATION
ATTENTION! Not to damage the Machine, never move it by holding the dispenser drawer, door
or gasket.
For transportation purposes, the drum of the Machine is fixed by locking bolts and spacer bars. Un-
screw the four bolts with a spanner and take out the spacer bars (Fig. 6). If the spacer bars remain inside the
Machine and would not get out, remove the back panel 1 (Fig. 7) with a crossblade screwdriver and take
the bars out. Reinstall the panel. Close the holes with plastic plugs, including in the kit. Keep the bolts and
spacer bars for future transportation.
NEVER operate the Machine with open spacer bar holes in the rear wall of the body.
INSTALLATION OF THE MACHINE
The Machine should be installed on a solid, even and dry surface. Soft flooring (carpets, polyurethane-
based coatings) is not recommended as it promotes vibration and degrades ventilation of the Machine.
When installed on a wooded floor, the Machine should be first placed onto a wooden slab at least
15 mm thick that is reliably bolted to the floor.
To increase the stability of the Machine during its operation on a wooden floor, it is recommended to
install the Machine in the corner of the room.
The Machine should be levelled precisely horizontally by screwing its adjustable supports 1 in or out:
loosen lock nuts 2 of the supports with a spanner, adjust the height of the supports, and tighten the lock
nuts (Fig. 8). A wrong installation of the Machine by its horizontal level and low tightening of the lock nuts
may be in the future a source of vibration and excessive noise during its operation.
Figure 6
38
1
Figure 7
2
1
Figure 8
Publicité
