Exquisit WA 6010 A+ Manuel D'exploitation page 42

EN
levels of dosing in ml are applied on the both sides of the shutter.
Shutter with numerals on the face should be installed in WA 6010 A+, , Machine, but with numerals
200, 150, 100, 50.
When installing in pan section 2, the shutter must moved on the guides in lower position freely.
When you are using SDs as powder, take the shutter out of the main wash compartment 2 (Fig. 15). Be
careful not to put any powder into the compartment for special treatment substances
foam may form during rinsing and white spots may appear on the items.
In case of a liquid SD, set the shutter into compartment 2 (Fig. 17) and pour the SD with the account
of the level marks on the shutter.
When choosing optional functions
SD, put it in right before washing.
Any overdosage of special treatment agents in the
and their getting into the neighbouring compartments will degrade the washing quality.
When choosing the program
the bleaching will take place immediately after the main washing.
ATTENTION! When using a bleacher, never set the optional function of pre-washing.
To improve the washing quality and protect the Machine from lime sediments, when washing in water
having hardness II or III, it is recommended to use, alongside with SDs, a water softener. It should be added
to the SD into compartment 2 (Fig. 15) according to manufacturer's guidelines.
The water hardness is defined according to Table 2. You may obtain data on your water hardness from
the local water supply entity.
Prior to start washing, close the drawer filled with the SD.
NEVER move out the detergent drawer, when the Machine is working, otherwise water may leak and
spray out of the Machine.
REMOVAL OF CERTAIN SPOT TYPES
Certain spots cannot be removed from items at usual machine washing. Therefore, they must be re-
moved manually before washing in the Machine. First try the process in an unseen place of the item, then
start from the edge of the spot and proceed towards its centre to avoid formation of blotchiness. See below
the removal methods of various spots.
Wax should be scraped off with a rounded object in order not to damage the cloth, then the item is
placed between two sheets of blotting paper and hot-ironed.
Spots from ball pens and felt pens are cleaned by means of soft cloth moistened in ethyl alcohol. Watch
for the spot not to bleed.
Spots of mould are removed at washing with adding of a bleacher into the bleacher tray (Fig. 15), if the
cloth withstands the effect of the bleacher. Otherwise, the dirty spot is moistened with 10-percent solution
of hydrogen peroxide and left for 15 minutes.
Light fabric burns left by an iron are removed in the same way as the mould spots.
Rust is removed by special rustremoving agents. Follow the manufacturer's guidelines.
YES
Figure 16
42
, place the SD into compartment 1. When using a liquid
(Spot Removal), put the bleachers into compartment 1 (Fig. 15), and
Shutter
NO
compartment (above the level MAX on the cap),
Figure 17
(Fig. 16), otherwise